Martensite to austenite reversion in a high-Mn steel: Partitioning-dependent two-stage kinetics revealed by atom probe tomography, in-situ magnetic measurements and simulation
File(s)
Accepted version
Author(s)
Type
Journal Article
Abstract
Austenite (γ) reversion in a cold-rolled 17.6 wt.% Mn steel was tracked by means of dilatometry and in-situ magnetic measurements during slow continuous annealing. A splitting of the γ-reversion into two stages was observed to be a result of strong elemental partitioning between γ and α′-martensite during the low temperature stage between 390 and 575 °C. Atom probe tomography (APT) results enable the characterization of the Mn-enriched reversed-γ and the Mn-depleted remaining α′-martensite. Because of its lower Mn content, the reversion of the remaining α′-martensite into austenite takes place at a higher temperature range between 600 and 685 °C. APT results agree with partitioning predictions made by thermo-kinetic simulations of the continuous annealing process. The critical composition for γ-nucleation was predicted by thermodynamic calculations (Thermo-Calc) and a good agreement was found with the APT data. Additional thermo-kinetic simulations were conducted to evaluate partitioning-governed γ-growth during isothermal annealing at 500 °C and 600 °C. Si partitioning to γ was predicted by DICTRA and confirmed by APT. Si accumulates near the moving interface during γ-growth and homogenizes over time. We used the chemical composition of the remaining α′-martensite from APT data to calculate its Curie temperature (TCurie) and found good agreement with magnetic measurements. These results indicate that elemental partitioning strongly influences not only γ-reversion but also the TCurie of this steel. The results are important to better understand the thermodynamics and kinetics of austenite reversion for a wide range of Mn containing steels and its effect on magnetic properties.
Date Issued
2019-03-01
Date Acceptance
2018-12-23
Citation
Acta Materialia, 2019, 166, pp.178-191
ISSN
1359-6454
Publisher
Elsevier
Start Page
178
End Page
191
Journal / Book Title
Acta Materialia
Volume
166
Copyright Statement
© 2018 Elsevier Ltd. All rights reserved. This manuscript is licensed under the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International Licence http://creativecommons.org/licenses/by-nc-nd/4.0/
Subjects
0912 Materials Engineering
0913 Mechanical Engineering
Materials
Publication Status
Published
Date Publish Online
2018-12-27